Material Safety Data Sheet   1/22/03            
(800) 451-1355 (805) 240-1300   Phone (805) 240-1301   Fax   
I.
PRODUCT INFORMATION
Product Name:  Laube Blade Dip
Product Class:  85 (Flammable) D.O.T. Proper shipping Name: ORM-D Consumer Commodity
General MSDS Information: (805) 240-1300
NFPA Codes: Health-0   Flammability-3    Corrosive-0   Reactivity-0
24 Hr. Emergency Assistance
Infotrac 800 535-5053 (352) 323-3500
Manufacturer:  Kim Laube & Co. Inc.
2221 Statham Blvd. Oxnard, CA 93033
SHIPPING INSTRUCTIONS:  Ground Only  (Do Not ship by Air)
II.
COMPONENTS
Component Component
Kerosene PEL: No Limit Triclosan
CAS #9002-05-9 TLV: No Limit CAS#3380-34-5
Highly Refined White Oil   PEL: No Limit
CAS # 8042-47-5   TLV: No Limit
III.
PHYSICAL DATA
Boiling Point or Range: Not Determined Vapor Pressure For Product: Not Determined
Vapor Density (Air=1): Not Determined Specific Gravity: 0.984
VOC: Not Determined Water Solubility: NIL
Appearance: Clear Purple Liquid
lV.
FIRE AND EXPLOSION HAZARDS DATA
Flash Point:  (TCC)  Flammable Classification: Level 3 Consumer Commodity
Extinguishing Media: CO2, dry chemical, foam, Halongenated extinguishing agent.  
Special fire fighting Procedures:  Summons professional firefighters.  Use protective equipment, including self-contained breathing apparatus.  Water may be ineffective.  If water is used, fog nozzles are preferable. 
V.
HEALTH HAZARD DATA
Threshold Limit Value:  See Section II
Eye Contact:  Slightly irritating but does not irritate eye tissue.
Skin Contact: Low Order of toxicity.  Frequent or prolonged contact may irritate and cause dermatitis.  Skin contact may aggravate an existing dermatitis condition.
Inhalation:  None
Ingestion: May cause nausea or vomiting, possible minimal toxicity. 
Chronic-reports have associated repeated breathing of spray mist and/or sanding dust over a period of years cause dust disease of the lungs. 
Emergency and First Aid Procedures:
Inhalation:  If you experience difficulty in breathing, leave the area to obtain fresh air.  If continued difficulty is experienced, summon medical assistance immediately.  If breathing ceases, restore using approved artificial respiration techniques and summon medical assistance immediately.
Eye Contact:  In case of eye contact, flush with large amounts of water for at least fifteen minutes.  If irritation persists get medical attention.
Skin Contact:  In case of skin contact, wash area thoroughly with soap and water.  Remove contaminated clothing,  Get medical assistance if irritation persists.
If Swallowed DO NOT INDUCE VOMITING.  Consult physician immediately.  
WARNING:  intentional misuse by deliberately concentrating and inhaling the contents may be harmful or fatal.
VI.
REACTIVITY DATA
Stability: Stable
Incomparability:  Avoid contact with strong oxidizing agents.
Hazardous Decomposition Products:  None
Hazardous Polymerization:  Will not occur.
Conditions to avoid: Not applicable
VII.
 PRECAUTIONS
Danger:  Flammable liquid and vapor.  Exposure to heat or prolonged exposure to the sun may cause busting.  Do not puncture, incinerate (burn) or store above 120°F or near open flame.  Do not reuse empty containers.  Keep out of reach of children.
Special Precaution: Health studies have shown that many hydrocarbons pose potential human health risks which may vary from person to person.  As a precaution, exposure to liquids, vapors, mists or fumes should be minimized.
Personal Protection: For open systems where contact is likely, wear safety glasses with side shields, long sleeves, and chemical resistant gloves.  Where concentration in air may exceeded the limits, work practice or other means of exposure reduction are not adequate NIOSH/MSHA approved respirators may be necessary to prevent over exposure by inhalation.
Ventilation: The use of mechanical dilution ventilation is recommended whenever this product is used in a confined space, and or agitated.
VIII.
Spill or Leak Procedures.
Steps  to be Taken in Case Container is Punctured and Material is Released:  Clean up area by mopping or with absorbent materials and place in closed container for disposal. Consult Federal, State and local Authorities for disposal.
Waste Disposal Method: Consult local authorities for proper waste disposal procedures.  Empty containers can not be reused yet can be recycled.
The information contained herein is based on data believed by Kim Laube and Company to be accurate, but we do not assume any liability for the accuracy of this information. We neither suggest nor guarantee that any hazards mentioned are the only ones that exist. Anyone intending to rely on any recommendation or to use any equipment, technique or material mentioned should also satisfy himself that he can meet all applicable safety and health standards. Determination of the suitability of any information or product for the use contemplated by any user, the matter of that use and whether their is any infringement of patents is the sole responsibility of the user.